EfalockBarber Classic Style Hair Clipper

Extremely powerful & gentle at the same time! With direct motor power to the blade the Classic Style Clipper is also suitable for extra thick and full hair and yet incredibly gentle to the skin. The high-performance battery achieves a cordless operating time of up to 5 hours.

Features:
Mains / battery operation
Battery: high-performance lithium Stage 3 battery without memory effect
Operating time: up to 300 min.
Charge time: 180 min.
Motor: high Performance Rotary Motor with up to 6500 rpm. for high, efficient cutting performance
Cutting set: made of hard carbon steel, innovative with oil sump and ventilation holes - for extra long life and reduced heat generation
Cutting length adjustment: 0.5 to 3.5 mm
Cutting head width: 45 mm
Cutting width: 40 mm
Handling: ergonomic & lightweight, low vibration, optimally balanced
LED indicator during mains operation
Weight: 280 g
Mains operation: 220-240 V | 50-60 Hz
Cable length: 1.5 m

Contents
6 magnetic comb attachments (1.5; 3; 4.5; 6; 10; 13 mm), cleaning brush, oil, power adapter

Use:
Cleaning the cutting head/replacing the side lever and/or its stepless adjustment:
Step 1: Loosen the two screws counterclockwise and remove the
cutting blades. Leave the plastic part, including the spring, in place.
Step 2: Unscrew the right screw only. This will lock the nut so you
can unscrew the side lever screw without it turning.
Step 3: Remove the side lever screw by unscrewing it counterclockwise
and place it next to the unit.
Step 4: If you want to remove the click system so you can work continuously,
remove the part you see circled. Save this!
Step 5: Replace the side lever and make sure it is back to the
correct tension. Test this by
moving the side lever up and down. This varies from person to person, but make sure it is not too tight
or too loose.
Step 6: Now you can loosen the right screw again counterclockwise.
Step 7: Oil the blades where indicated.
Step 8: Replace the blades by tightening the screws clockwise.
Don't tighten them all the way yet, because you still need to check if the blade is straight and how
short it needs to be adjusted. Adjust the blades to be short and straight, and then tighten the
screws. Be sure to keep the blades straight!